跳至主要内容

Suggestions from tire shredder manufacture

The tire shredder is mainly used for grinding tires, wire tires, wire tires (radial tires) and various waste rubber products or trims to make it into a rubber powder and achieve the required fineness (mesh). At present, the tire shredder equipment, whether it is waste rubber or used tires, can be subjected to normal shredding treatment, and has become a special shredding device for used tires. As a tire shredder manufacturer, we recommend that you pay attention to the following points in the process of use:

First of all, be sure to follow the operating procedures in strict accordance with the operation. During the process of starting the tire shredder, the tool, electric control, and body shall not be manually cleaned, parts or parts may be replaced or the machine shall be lubricated and maintained;

Secondly, during the operation, it is forbidden to extend any part of the human body into the body of the tire shredder to prevent the moving parts from being caught or crushed; there must be no oil or corrosive chemicals.

Finally, the tire shredder is turned on again after a period of suspension, and a thorough inspection of the machine is required to ensure that the components of the tire shredder are intact and that there are no foreign objects that may affect the operation. The adjustment of the drive unit and the adjustment of various safety protection devices shall be performed by a full-time staff.

标签：

评论

发表评论

此博客中的热门博文

What if the plastic shredder is blocked

Plastic shredder is specially designed to tear up plastics, building templates, wooden pallets and other waste wood, long time to tear up the work, there may be some problems. For example, in the process of production, fast feed, plastic shredder suddenly appeared blocked, what to do? Plastic shredder, congestion is more common problems are basically caused by not timely maintenance, regular cleaning, accumulate over a long period, can jam during production, not only affect the production, can also harm the plastic shredder. This is the reason why the plastic shredder is blocked. Plastic shredder failure requires you to pay attention to in time, if it is found that the shredding machine production, and the same raw material, check the damper is in place and pipes with and without air leakage, etc., the shredding machine jams are common faults, the possibility is there are four: 1: may be the body design problem; 2: the raw material is put in too fast; 3: it is the pipe of the discharg...
发表评论
阅读全文

Scrap metal shredder

发表评论
阅读全文

Start up and operation steps of dual shaft shredder

The industrial shredder expert explains the steps of starting the dual shaft shredder: 1. The starting motor of the dual shaft shredder operates under no load. If the technical conditions of each part are normal, it can only operate under load after the rotating speed is normal. 2. During the operation of the dual shaft shredder, there shall be no magnetic jamming and friction sound. 3. The screen shall be installed firmly, sealed, without leakage, and the screen frame shall be fixed tightly. 4. In case of abnormal noise, blocked discharge, overheated bearing or motor during the operation of the dual shaft shredder, stop feeding, stop inspection and troubleshooting. 5. At the end of the work, the crusher and fan can be stopped only after the materials in the machine are completely removed. 6. Safety production must be strictly guaranteed during operation. Do not increase the speed of the dual shaft shredder at will. Check the cotter pin on the pin shaft frequently. If it is excessivel...
发表评论
阅读全文