跳至主要内容

Brief introduction of the dry powder mixer components

Below are some simple  introduction for the components of the dry powder mixer equipment.
 
1. High-life mixed barrel
1) The cylinder material is made of high quality and high wear resistant alloy steel plate.
2) Wear-resistant lining can also be installed in the cylinder.
2.Reliable shaft end seal
1) The mixing spindle shaft end seal of the dry powder mixer machine adopts a very reliable micro grease rubber sealing technology. The bearing and the shaft end seal are completely separated to ensure the safe operation of the bearing, so that the design is convenient for the maintenance of the bearing and the seal.
2) The spare sealing rubber is carefully prepared in the shaft end of the mixing spindle, and the sealing rubber can be replaced without removing the shaft end cover and the shaft end seat.
3.Efficient mixing device
1) The hybrid spindle adopts an integral solid shaft with better torsion and bending strength.
2) All mixing blades are made of high-chromium alloy wear-resistant cast iron, and tungsten carbide is deposited on the surfaces of the mixing arms and small blades to ensure wear resistance.
3) The pigment can be evenly dispersed to eliminate the color difference after the finished product is mixed.
4) A small amount of admixture can be uniformly dispersed, so that the addition amount of the admixture can be as low as 1:10000.
 
The components of the dry powder mixer machine can fully meet the requirements of the machine in the production process, the manufacturing process is advanced, and the selected materials are of high quality.

评论

发表评论

此博客中的热门博文

What if the plastic shredder is blocked

Plastic shredder is specially designed to tear up plastics, building templates, wooden pallets and other waste wood, long time to tear up the work, there may be some problems. For example, in the process of production, fast feed, plastic shredder suddenly appeared blocked, what to do? Plastic shredder, congestion is more common problems are basically caused by not timely maintenance, regular cleaning, accumulate over a long period, can jam during production, not only affect the production, can also harm the plastic shredder. This is the reason why the plastic shredder is blocked. Plastic shredder failure requires you to pay attention to in time, if it is found that the shredding machine production, and the same raw material, check the damper is in place and pipes with and without air leakage, etc., the shredding machine jams are common faults, the possibility is there are four: 1: may be the body design problem; 2: the raw material is put in too fast; 3: it is the pipe of the discharg...
发表评论
阅读全文

Scrap metal shredder

发表评论
阅读全文

Start up and operation steps of dual shaft shredder

The industrial shredder expert explains the steps of starting the dual shaft shredder: 1. The starting motor of the dual shaft shredder operates under no load. If the technical conditions of each part are normal, it can only operate under load after the rotating speed is normal. 2. During the operation of the dual shaft shredder, there shall be no magnetic jamming and friction sound. 3. The screen shall be installed firmly, sealed, without leakage, and the screen frame shall be fixed tightly. 4. In case of abnormal noise, blocked discharge, overheated bearing or motor during the operation of the dual shaft shredder, stop feeding, stop inspection and troubleshooting. 5. At the end of the work, the crusher and fan can be stopped only after the materials in the machine are completely removed. 6. Safety production must be strictly guaranteed during operation. Do not increase the speed of the dual shaft shredder at will. Check the cotter pin on the pin shaft frequently. If it is excessivel...
发表评论
阅读全文