跳至主要内容

Five threaded connections for dry powder mixer equipment

Contact Person：Mr.Zhao 0086-13523465141
Dry powder mixers use bolted links to join the parts that need to be fixed together. This type of connection is called a threaded connection. It can be seen that threaded connection plays an important role in the dry powder mixer.
1. Dry powder mixer bolt connection: The bolt connection package is connected by the bolt connection and the shear bolt.
2. Stud connection: Both ends of the stud link screw have threads at both ends. When assembled, one end is screwed to the connected piece and the other end is equipped with a nut. It is suitable for the case where one of the connected parts is thick and needs to be disassembled. It is only necessary to remove the nut when disassembling, and it is not necessary to unscrew the stud from the connector.
3. Set screw connection: Fixed screw joints usually have threads. After screwing, the end of the screw is used to hold the surface of another part or to screw into the corresponding notch of the part, so that the relative position of the fixed part can transfer little axial force or torque.
4. Dry powder mixer screw connection: The screw connection is suitable for the thicker one of the connected parts. When there is no need to disassemble, there is a six-point head at one end and no nut is needed.
5. Dry powder mixer threaded joints: There are many types of threaded joints. In the mechanical production, the structural form and size of the threaded joints have been standardized, and the design can be selected according to the relevant standards.

评论

发表评论

此博客中的热门博文

What if the plastic shredder is blocked

Plastic shredder is specially designed to tear up plastics, building templates, wooden pallets and other waste wood, long time to tear up the work, there may be some problems. For example, in the process of production, fast feed, plastic shredder suddenly appeared blocked, what to do? Plastic shredder, congestion is more common problems are basically caused by not timely maintenance, regular cleaning, accumulate over a long period, can jam during production, not only affect the production, can also harm the plastic shredder. This is the reason why the plastic shredder is blocked. Plastic shredder failure requires you to pay attention to in time, if it is found that the shredding machine production, and the same raw material, check the damper is in place and pipes with and without air leakage, etc., the shredding machine jams are common faults, the possibility is there are four: 1: may be the body design problem; 2: the raw material is put in too fast; 3: it is the pipe of the discharg...
发表评论
阅读全文

Scrap metal shredder

发表评论
阅读全文

Start up and operation steps of dual shaft shredder

The industrial shredder expert explains the steps of starting the dual shaft shredder: 1. The starting motor of the dual shaft shredder operates under no load. If the technical conditions of each part are normal, it can only operate under load after the rotating speed is normal. 2. During the operation of the dual shaft shredder, there shall be no magnetic jamming and friction sound. 3. The screen shall be installed firmly, sealed, without leakage, and the screen frame shall be fixed tightly. 4. In case of abnormal noise, blocked discharge, overheated bearing or motor during the operation of the dual shaft shredder, stop feeding, stop inspection and troubleshooting. 5. At the end of the work, the crusher and fan can be stopped only after the materials in the machine are completely removed. 6. Safety production must be strictly guaranteed during operation. Do not increase the speed of the dual shaft shredder at will. Check the cotter pin on the pin shaft frequently. If it is excessivel...
发表评论
阅读全文