跳至主要内容

How to disassemble the bearing of calcium carbonate grinding mill

Contact Person:Mr.Zhao 0086-13523465141
Nowadays calcium carbonate grinding mill is gradually becoming an important equipment in the grinding industry.Well,as an important part of calcium carbonate grinding mill,bearing plays an important part in the working process.For calcium carbonate grinding mill, the installation, use and disassembly of equipment need to follow strict steps. For the bearings of the grinding machine, we need to pay attention to correct ways when we need to disassemble them.
First of all, when disassembling bearings, we should pay attention to the selection of disassembly tools and the correct disassembly steps and sequence, strictly abide by these can effectively prevent the damage of the accessories around the bearings. When disassembling, first turn the bearing device out, then check the end clearance of the grinding roller bearing, remove the roller sleeve and shaft assembly from the grinding roller head, and pull the inner ring of the bearing out of the grinding roller shaft after one disassembly of the fittings. Then the grinding roller bearing seat is removed from the grinding roller shaft. At this time, the upper and lower outer rings of the bearing remain in the bearing seat. The appropriate tools are selected to pull the outer rings of the bearing out, so that the disassembly step of the bearing is completed.

评论

此博客中的热门博文

How to Avoid Faults in Aluminum shredder

The main purpose of scrap  aluminum shredder  equipment is to tear all kinds of unqualified scrap iron into smaller pieces for recycling. Reduce the volume of unprocessed raw materials for mixing with other materials. How to avoid equipment failure in daily production of scrap aluminum shredder equipment?   1. Check and clean in time. After work every day, the machine should be cleaned in time. Check screw loosening and abrasion of easily worn parts such as claws, sieves, etc. http://www.sg-shredder.com/News/Industry_News/755.html

What to do if the metal shredder discharges unevenly

 In the course of use, the metal shredder has uneven discharge. Through analysis, Shuguang heavy machinery summarized the following reasons. First of all, because the voltage is unstable, it will affect the stability of the motor, resulting in uneven speed, fast and slow and other problems, which will worsen the uneven discharge. When the feed is uneven, it is easy to block and cause the cavity to become clogged. Fully process unfinished materials. In severe cases, many blockages may cause downtime or increase in motor temperature.  Secondly, the motor is unstable. When the voltage is stable, following the change of the force endured by the transmission, the fixed point of the motor will be displaced and the base screw will be loosened.  Therefore, it is necessary to check whether this part is complete. First, the current professional standards for shredders are not standard, and the supporting shredder blade standards are also complicated. The shredder produced by the s...

How to deal with the heating problem of shredder motor

When we use the motor for a long time, there will be the problem of motor heating. The motor will lack of oil after a long time, which will affect the production efficiency of the whole shredder equipment . If the motor is hot or burnt, there is no way to tear it. How to avoid the phenomenon of motor heating of the shredder? 1. The adjustment of the tension of the V-belt of the shredder equipment, when the V-belt is too tight, the motor bearing heats up, when the V-belt is too loose, the rotation speed decreases, and the V-belt is easy to slide, which all affect the service life. When adjusting the tension of the V-belt, the bolt fixing the motor base can be loosened, and the position of the motor on the slide way can be changed with the adjusting bolt, so that the V-belt can reach the required tightness, and then the fixed bolt can be tightened; 2.After the shredder motor works for a certain period of time, it is necessary to add oil or open the cleaning bearing and refill the file ba...